b)．聯軸器與泵機組是否校正 C)．管路是否按要求連接；
d)．手是否能容易地轉動轉子 e)．是否所有軸承都有良好的潤滑 2)、起動前關閉出口閥 2、運行：
1) 2) 3) 4)、為防止介質升溫，泵不能在出口閥門關閉的情況下長期運轉；
5)、當周圍的環境溫度達到30℃時 6)、使用稀油潤滑 7)、檢查聯軸器上的彈性元件 8) 3、停止：
1) 2) 3) 4)、當輸送的介質為對健康有害的液體時 說明： |
Samely, for the pump set with common bedplate.
Fit the pre- assembled set with foun- dation bolts loosely inserted in the cut-
outs in the foundation and align. There must be a 4- 5cm gap between the top of
the foundation and the bottom of the baseframe. Precisely align the set using
the adjusting screws and check alignment on the coupling. Others you can refer
to the above mention methods.
1. Starting:
1) . Before starting up the
pump make sure that the following requirements have been checked and fulfilled.
a) . Has the pump been
firmly bolted to the base/foundation?
b) . Have the coupling and
pump unit been aligned as specified?
c). Are the pipes properly
fitted?
d). Can the unit be easily
rotated by hand at the coupling? (Carry
out at least one full rotation)
e) . Has lubrication been
provided for oil -lubricated bearings?
2) Before the pump is
started up, it and the pipes must be vented and filled with the liquid to be
pumped. In the case of both gravity feed and suction operation venting must be
carried out via the hole on the upper suction elbow. In the case
of
suction operation the upum must additionally be evacuated(a vacuum must be
created).
2. Running:
1) . As soon as the pump starts to
deliver this can be recognized by the rising gauge pressure slowly open the
delivery gate valve fully.
2). All additional
connections for cooling, heating, lubrication irrigation or sealing liquid etc,
if fitted, must be opened fully or switched on and the flow must be checked.
3). Screw homogenizenously
the nuts on the pump packing gland so as to the leakage of liquid is little, at
the same time, pay more attention to the packing case temperature rising.
4). Prolonged operation
against a closed shut-off element is not permitted in order to prevent the
medium handled from heating up.
5). At room temperatures of
up to 30℃ the bearing
temperature should not exceed 90℃. At higher room
temperature the bearing temperature should be below 1O0℃.
6). If the pump features
oil-lubricated
|