The pump component
parts are impeller, pumphouse,pump covers, discharging valve, etc. The pump
revolution is drove by the diesel engine through the pump shaft directly. Pump
water-exit direction can be changed because the revolution scope of the discharging
valve is 180 degree.
The self-palming
function is carded out by the vane pump and it outfitted the clutch controlled
by handle and the V-belt driven by the diesel engine, to outgoing the air in
the suction fine, generate vacuity and to achieve in the end when spraying of
the discharge opening for the water guider, meantime the clutch can self-reset soon
alter easing off the handle and the stop cock of lhe water guider can self shut
off.
|
1.pumphouse 2.belt wheel
3.tensioner 4.water guiding handle
5.cover
of oil cup 6.oil cup
7.belt
cover.
|
 |
1)Preparing before starting: Must read
earnestly and particularly the ‘Diesel Engine operating Instruction' and ‘CWY
Type Diesel Engine Fire Pump Operating Instruction' to know and mastery the
pump unit operating method before staring.
①Check the L/O of the Diesel Engine and make sure
the oil quantity should be kept in between upper and lower margin fine. Must
use the CC-CD class L/O. Using the CC30 or CD30 in the summertime, and using
.the CC20W/20 or CD20W/20 in the wintertime.
②Check the Diesel Engine oil tank capacity and
make sure use the fight oil and Max. oil capacity can not exceed the red limit
mark. Don't let the ash or water going into the oil tank. Inspect make sure the
electric circuit up to grade.
③Check the oil cup oil qtmntity water guider, it
does not allows to operate when without oil.
④Full fill L/O in the
lacuna of the mechanical shaft seals to avoid dry friction.
⑤Fit suction line, discharge hose and water wheel
and shut off deasil the discharge valve. The highest point of the suction water
pipe can not exceed the suction opening to avoid the air go into and form
air-bag.
2)Start the Diesel Engine:
① Turn on the switch of D.O. tank.
②To remove the Diesel Engine timing control
handle to the middle location follow the direction of 'Operation' position.
③Hand draw start: the right hand hold closely the
start handle and slowlydraw until it can not be drew, at this time, sent out
the handle and let it reset slowly, then press decompress handle and loose
slowly. Hold closely the start handle, stain the rope, amain draw apart the
rope (use both hands if necessary) . The diesel engine completing start in this
moment. Should it could not be started, repeat again. Increasing the speed in
2-3 minutes after starting except for emergency.
Note: if electrical starting, please read
the ‘Diesel Engine
operating Instruction'
④Using the electric start
in the condition without affecting the safety, run the start switch snob to
start the diesel engine. (In the occasion forbidding using the storage battery:
the diesel engine unit not allow to outfit the storage battery starting
system.) .
|