量的50％-120％。
Quantity of flow of the pump should be kept within the allowable extent
recommended by the manufacture．This extent is generally 50％to 120％of the rated quantity of flow．
4.2.3注意軸承溫升 Take
care of the temperature rise of the bearings．Surface temperature of the
beatings should not exceed 75℃ 4.2.4停機后應關閉出口閥 After the pump is stopped，the outlet valve should be turned
off．If power supply fails suddenly during operation 5.1．泵進口管應裝濾網，以防止堵塞泵體和葉輪 The filler should be installed at the inlet pipe to prevent the
non-return valve in the pump body from being blocked by rubbish．
5.2．在運轉中隨時注意是否有異常震動、噪聲 During
operation take care all the time whether extraordinary vibration noise exists．
5.3．泵要長期停止使用時 If the
pump is going to be out of use for a long time 5.4．泵的軸承每三個月要加注一次黃油。每一萬小時后檢查軸承滾珠是否有剝落的現象 Lubricating grease should be added to the bearing of the pump every three
months．The surface of the ball bearings should be examined whether
exfohation occurs after every 10,000 hours of use．Replace
the bails when necessary．
5.5．烈本和泵蓋上的啪侖密封環掣特次磨捌煸蝕情況，必要時應予以更換 The
situatiOn of wear and tear and corrode of the seal ring of the valve on the
pump body and the pumP cover should be examined for every year,replace the seal
ring when necessary．
5.6．機械密封每年檢查一次 The
machinery sealing should be examined for every years |